This bed has been specifically designed for a person who requires carers.
The design allows for a person to be turned in bed at a comfortable height. It also assists the person to stand up from a seated position on the edge of the bed, in much the same way as a rise and recline chair works. Only the middle (flat) section can be used for this process whilst the bed is in its profiled position.
The mechanism can be raised up to 18 inches from the starting height. It can be raised flat for turning the patient or profiled as shown in the picture above (head and/or foot elevated.
This frame can be installed into any of our adjustable bed surrounds (Excludes Chatsworth and Sandringham).
Altering the length means altering the mattress, mattress cover, mechanism and surround
Single bed altering the length £ 195
Altering the height of bed £ 75
Available in 2ft 6, 3ft and 4ft
Bed Height (From floor to top of mattress)
The minimum starting height can be 21.5 inches from the floor to the top of the mattress. The standard starting height is 23.5 inches.
- 5-part adjustable profiling with integral rise and lower facility
- 4 motors (2 for profiling and 2 for lift)
- Vertically rises up to 18 inches from starting point
- Weight adjuster zone in lumber area
- Centre belt
- Load-bearing points bolted and sleeved.
- Maximum weight capacity 25st
The single vertical lifting frame can be put into any of our adjustable bed surrounds, so choose the bed you like (from the all adjustable beds page) and add the cost of the single vertical lifting frame (in the mechanisms drop down box on any bed product page ), or simply choose the combination as shown on this page..
Cost Breakdown (example)
Bed Cost £799.00
Head & Footboard £199.00 (optional)
This bed comes without the underbed cut outs shown in the image, which are vital in order to use a hoist. If these are required, please add this via the dropdown option above.
Dual beds have independent controls and independent matttresses. You will generally have a vertical lifting mechanism on one side of a dual bed, so if you are purchasing a 5ft dual bed you will only need one 2ft 6 vertical lifting mechanism.
Double beds have one mattresses, two vertical lifting mechanisms with a special linking cable, if the person always uses only one side it will go out of sinc and by about 1 inch and will have to be raised to the highest position to align again most times it is used.
The picture shown is a single bed.
This bed can also come in a double or dual size.